牌号简介 About |
---|
Hylar® 5000 HG是聚偏氟乙烯(PVDF)的结晶高分子量粉末形式,专门为溶剂型涂料设计,以提高光泽。它形成了机械强度高、硬度大、使用温度范围广的薄膜。这些薄膜对包括伽马辐射在内的大多数环境条件都有很高的抵抗力,并且对紫外线辐射基本上是透明的。Hylar® 5000 HG-27涂层的耐候性使其长期性能优异。Hylar 5000只能通过指定Hylar® 5000 HG涂层成分的许可计划获得。适当配制的饰面含有足够的颜料,使薄膜在建议的标称1密耳(0.001英寸)薄膜厚度下完全不透明,不受紫外线辐射影响。安全Hylar® 5000 HG在最高600°F(316°C)的温度下稳定。当其长期处于600°F(316°C)以上的温度下时,氟化氢(HF)开始演化,在700°F(371°C)以上的温度下,HF迅速演化。Hylar® 5000 HG具有优异的阻燃性;但是,在发生火灾时,可能会形成氢氟烃和少量潜在有毒的碳氟化合物。HF具有腐蚀性,接触后会导致烧伤,美国政府工业卫生学家会议(ACGIH)的阈值(TLV-TWA)为3 ppm(2.5 mg/m³)(1984年)。如果温度控制不当,在烘箱中也可能发生Hylar® 5000 HG到HF的热分解。如果发生火灾,使用NIOSH认可的自给式呼吸器和皮肤保护装置,以防止挥发性分解产物。Hylar® 5000 HG可在批准的土地填料中处理,但不得焚烧,除非适用法律允许并规定吸收HF。 Hylar® 5000 HG is a crystalline high molecular weight powder form of polyvinylidene fluoride (PVDF)specifically designed for solvent-based coatings to provide improved gloss. It forms mechanically strong and tough films that have a broad useful temperature range. These films are highly resistant to most environmental conditions including gamma radiation and are essentially transparent to ultraviolet radiation. The weathering characteristics of Hylar® 5000 HG coatings lead to excellent performance for the long term. Hylar® 5000 is available only via a licensing program that specifies the composition of Hylar® 5000 HG coatings. A properly formulated finish contains sufficient pigment to make the film totally opaque to ultraviolet radiation at the nominal one mil (0.001 inch) film thickness suggested. SAFETY Hylar® 5000 HG is stable at temperatures up to 600°F (316°C). When it is subjected to temperatures above 600°F (316°C) for extended periods of time, hydrogen fluoride (HF) begins to evolve, and at temperatures above 700°F (371°C) HF evolution becomes rapid. Hylar® 5000 HG exhibits excellent flame resistance; however, in case of fire, HF and traces of potentially toxic fluorocarbons can be formed. HF is corrosive, causes burns on contact, and has an American Conference Governmental Industrial Hygienists (ACGIH) Threshold Limit Value (TLV-TWA) of 3 ppm (2.5 mg/m³) (1984). Thermal decomposition of Hylar® 5000 HG to HF can also occur in a bake oven in the event that temperatures are not controlled properly. In the event of fire, use NIOSH approved self-contained breathing apparatus and skin protection to protect against volatile decomposition products. Hylar® 5000 HG can be disposed of in an approved land fill, but should not be incinerated unless permitted by applicable law and provision is made for absorption of HF. |
产品描述 Product Description
厂家:比利时索尔维 Solvay
类别:PVDF PVDF
用途:薄膜;涂层应用;
颜色:白色
加工条件:涂层
性能特点: 机械强度好; 低VOC; 抗伽马射线; 高分子量; 高纯度; 结晶; 表面光泽度好; 韧性好; 耐候抗UV; Good Rigidity,Weather resistance is good,Good flexibility,High purity,Good surface appearance,Crystal,Gamma radiation,Low odor,High molecular weight
技术参数 Technical Data | |||
---|---|---|---|
热性能 THERMAL |
额定值 Nominal Value |
单位 Units |
测试方法 Test Method |
熔融温度 Melting temperature |
164 到 167 | ℃ | ASTM D3418 |
光学性能 optical performance |
额定值 Nominal Value |
单位 Units |
测试方法 Test Method |
光泽度 gloss |
|||
60° 60° |
40.0 | min | ASTM D523 |
补充信息 Supplementary information |
额定值 Nominal Value |
单位 Units |
测试方法 Test Method |
分解温度 decomposition temperature 4 |
382 到 393 | ℃ | TGA |
细度 fineness |
|||
分散 disperse |
5.50 到 6.00 | ASTM D1210 | |
物理性能 PHYSICAL |
额定值 Nominal Value |
单位 Units |
测试方法 Test Method |
密度 Density 2 |
1.75 到 1.77 | g/cm³ | ASTM D792 |
吸水率 Water absorption rate |
|||
平衡 balance |
% | ASTM D570 | |
纯度 purity |
|||
PVDF PVDF |
% | ||
含水量 water content 3 |
% | ||
熔体表观粘度 Apparent viscosity of melt |
Pa·s | ASTM D3835 |
备注 |
---|
1 一般属性:这些不能被视为规格。 |
2 23/23°C |
3 非吸湿性 |
4 1% 重量,损失在空气中 |
【新闻资讯】查看全部
阿曼敲定建造45亿美元塑料厂协议
2015-12-01 阿曼石油精炼和石油工业公司(Orpic)日前完成了与4家优先投标者就投资45亿美元建造新塑料厂的协议所进行的谈判。 据外媒报道,这些协议主要针对在苏哈尔建造一个被称为利瓦塑料工业联合体的主要塑料制造厂,它是4个工程设计、采购和施工(EPC)包中的一个。 此外,第二个开发项目基本上是一个耗资28亿美元的蒸汽裂解装置及有关设施,这个项目将由美国芝加哥桥梁钢铁公司和中国台湾中鼎工程股份有限公司(CTCI)共同实施。 组成塑料厂的第三个项目将授予意大 |
阿曼敲定建造45亿美元塑料厂协议 阿曼石油精练和石油工业生产公司(Orpic)日前完成了与4家优先选择招投标者就项目投资45亿美金修建新塑料厂的协议书所开展的交涉。 据外媒报道,这种协议书关键对于在苏哈尔修建一个被称作利瓦塑胶工业联合的关键塑胶生产厂,它是4个建筑工程设计、购置和工程施工(EPC)包中的一个。 除此之外,第二个开发设计项目大部分是一个斥资28亿美金的蒸气裂化设备及相关设备,这一项目将由美国波士顿公路桥梁钢材公司和台湾中鼎工程项目股份有限公司公司(CTCI)一同执行。 构成塑料厂的第三个项目将授于西班牙知名工程项目公司澳波尼蒙特公司(Tecnimont),后面一种把燃气液體提炼厂项目交给了由日本GS建设工程公司和日本三井公司构成的大财团。 来源于:雅式橡塑制品网 |
【免责声明】 广州搜料信息技术有限公司保留所有权利。 此数据表中的信息由搜料网soliao.com从该材料的生产商处获得。搜料网soliao.com尽最大努力确保此数据的准确性。 但是搜料公司对这些数据值及建议等给用户带来的不确定因素和后果不承担任何责任,并强烈建议在最终选择材料前,就数据值与材料供应商进行验证。 |
价格走势图
开始时间:
结束时间:
材料厂家:
【牌号齐全,内容全面】
全网共2500+项牌号+上游原料单体+原油价格,最长可追溯近20年价格行情
【精准,及时,权威!】
专业团队挖掘行情信息,第一时间发布行情
抱歉!该牌号暂无认证数据。
免责声明:参考价格是搜料网根据网络大数据拟合分析的结果,仅供参考。实际成交价取决但不限于以下因素:下单时间,付款方式,交货方式,数量,税费,色号,产地,项目信息。
抱歉!暂无数据。
抱歉!暂无数据。